TENSOL 12 Acrylic Adhesive, 50ml Bottle/Perspex Bonding Glue Cement

Product Information

Cover the container and allow the mixed adhesive to stand for 5 minutes to allow the larger air bubbles to

The adhesive will be hardened sufficiently within one and a half hours to allow careful handling of the Liquid solvent is applied using a brush or a syringe (often supplied with the glue). As it is a liquid, it is drawn along joints and surfaces through a process called capillary action. Care must be taken, as the glue damages exposed surfaces (as it melts the surfaces of the materials forming a ‘weld joint’). Tensol 70 is designed for bonding cast acrylic sheet. It will also bond extruded acrylic sheet, but will cause Do not use adhesive that has been mixed for more than 20 minutes as it will be difficult to use and giveBefore using Tensol 12 store the adhesive at 5 to 10oC for 12 hours to reduce solvent evaporation between applying the adhesive and assembling the parts. Dispense the adhesive from a small polythene bottle SW or AG grades and is not suitable for laminating sheets. Typical bond strengths are 24 MPa for a cold

dissolved in solvent for the bonding of acrylic sheet for interior use only. Tensol 12 hardens as the solvent Accurately weigh 5 parts of Part B into 100 parts of Part A. It is important that this is done accurately for 3 to 4 hours at 80oC. Thermoformed, highly stretched components may be heated for 4 to 5 hours at sheet can be used if it is suitably annealed prior to bonding. Tensol 12 must not be used with Perspex ME, They should be left twenty four hours before taking out. This glue is very strong as it 'fuses' bothAn alternative to a vice is a set of G-Cramps. These spread the pressure across the surfaces being joined, in much the same way as a vice. Notice the wood lengths that protect the ‘plastic’ and evenly distribute the pressure from the clamps. petroleum ether or white spirit then washed with water. Extruded or machined parts should be annealed Select an adhesive (Tensol), which joins plastics such as acrylic, together permanently. Tensol is also called ‘dichlormethane methyl methacrylate’ and produces a chemical weld between two surfaces. Tensol is applied to the surfaces to be glued and they are pressed together. The surfaces are clamped for 24 hours. perspex together permanently. Tensol cement is a type of glue called ‘dichlormethane methyl methacrylate’ and produces a chemical weld between two surfaces. The glue is applied to the surfaces to be glued and they are pressed together. They should be clamped for 24 hours and this gives a permanent joint.

Once the adhesive has set the final bond strength can be increased by heat curing the material. This can assembly. After 4 hours cure the parts can be lightly machined but, for the best results, the joint should be The bonds obtained using Tensol 70 are of approximately the same strength as the acrylic sheet. TypicalThoroughly mix the adhesive by stirring, taking care to entrap as little air in the adhesive as possible. The only be done at least one hour after the adhesive has set. Non-thermoformed components can be heated Tensol 70 is a two component, acrylic adhesive which hardens at room temperature by the polymerisation

shrinks on curing allowance must be made for this when making butt joints and fillet joints. When bonding

RETURNS

edge to face the edge should have a 10o chamfer to allow a sufficient quantity of adhesive into the joint.